A., Chrysanthou and Dr., O. P. Modi and Li, Han and N. , Ramakrishnan and J.M., O'Sullivan (2008) Formation and microstructure of (Ti, V) C-Reinforced iron matrix composites using self propagating high-temperature synthesis. International Journal of Materials Research, 99. pp. 281-286. ISSN 1862-5282

B K , Prasad (2008) Sliding Wear Characteristics of a Gray Cast Iron as Influenced by the Sliding Speed, Load and Environmen. Tribology- Materials, Surfaces and Interfaces.

B K , Prasad (2008) Sliding Wear Response of Spheroidal Graphite Cast Iron as influenced by Applied Pressure, Sliding Speed and Test Environment. Canadian Metallurgical Quarterly.

B K , Prasad and Dr., O. P. Modi (2008) Sliding Wear Response of Zinc-Based Alloy as affected by Suspended Solid Lubricant Particles in Oil Lubricant. . Tribology - Materials, Surfaces and Interfaces.

B K , Prasad and Dr., O. P. Modi and A H , Yegneshwaran (2008) Wear Behaviour of Zinc-Based Alloys as Influenced by Alloy Composition, Nature of the Slurry and Traversal distance. Wear, 264. ISSN 0043-1648

B K , Prasad and Mohini , Saxena and R K , Morchalle and Asokan, Pappu (2008) Plant Fibre Industrial Waste Reinforced Polymer Composites as a Potential Wood Substitute Material. Journal of Composite Materials.

B., Srivathsa and N. , Ramakrishnan (2008) An analytical model for explosive compaction of powder to cylindrical billets through axial detonation. CMC- Computers Materials & Continua, 7. pp. 9-23. ISSN 1546-2218

Bajpai, S.K and Chand, N and Mary, G (2008) A Novel Approach to Prepare Zn(II) Loaded Cotton Fibres with Antibacterial Property. Journal of Macromolecular Science Part A.

Chand, N and Jain, D and Nigrawal, A (2008) Dielectric Behaviour of Maleic Anhydride Grafted Polypropylene (MA-g-PP) Modified Sisal Fibre Reinforced PP Composites. Journal of Natural Fibres.

Chand, N and Nigrawal, A (2008) Investigations on DC Conductivity Behaviour of Milled Carbon Fibre Reinforced Epoxy Graded Composites. Bulletin of Materials Science. ISSN 0250-4707

Chand, N and Sharma, M.K (2008) Development and Sliding Wear Behavior of Milled Carbon Fibre Reinforced Epoxy Gradient Composites. Wear. ISSN 0043-1648

Chandra, N and S S, Amritphale and Baghel, N.S and Voskresenskaya, E.N and Pashkov, G.L. and Sharma, P (2008) Coal Fly Ash Utilization: Low Temperature Sintering of Wall Tiles. Waste Management.

D.P., Mondal and E M, Vinod and S , Das and T S V C , Rao (2008) Investigations on d.c. conductivity behaviour of milled carbon fibre reinforced epoxy graded composites. Investigations on d.c. conductivity behaviour of milled carbon fibre reinforced epoxy graded composites, 15. pp. 41-50. ISSN 0971-4588

D.P., Mondal and E.M., Vinod and S , Das and T.S.V.C, Rao (2008) High stress abrasive behavior of shot peened AA2014A1-alloy. Ind J of Engineering and Materials Sciences, 15. pp. 41-50.

D.P., Mondal and Goel, M.D and S , Das (2008) Effects of Strain Rate and Relative Density on Compressive Deformation Behaviour of Closed Cell Aluminum–Fly Ash Composite Foam. Materials & Design.

D.P., Mondal and S , Das and Vinod, E.M and Rao, T.S.V.C (2008) High Sress Abrasive Wear Behaviour of Shot Peened AA2014 Al-Alloy. Indian Journal of Engineering Materials Science.

DasGupta, R and Meenai, Humaira (2008) High Stress Abrasive Wear Behaviour of Al-2014 alloy and its SiC Composite. International Journal of Microstructure and Materials Properties.

Dr., Navin Chandra and Priya , Sharma and G.L. , Pashkov and E.N. , Voskresenskaya and S S, Amritphale and S, Narendra and Dr., Baghela (2008) Coal fly ash utilization: Low temperature sintering of wall tiles. Waste Management, 28. pp. 1993-2002. ISSN 0965-053X

Dr., Navin Chandra and U.K., Dwivedi (2008) Sliding wear and friction characteristics of sisal fiber reinforced polymer composites:effect of silane coupling agent and applied load. POLYMER COMPOSITES, 29. pp. 280-284. ISSN 0272-8397

Dr., S A R Hashmi and Dr., Pratibha Sharma and Navin, Chand (2008) Thermal and Rheological Behavior of Ultrafine Fly Ash Filled LDPE Composites. Journal of Applied Polymer Science, 107. pp. 2196-2202. ISSN 0021-8995

Dr., S A R Hashmi and Dr., U K Dwivedi (2008) SiC Dispersed Polysulphide Epoxy Resin Based Functionally Graded Material. POLYMER COMPOSITES. pp. 1-7. ISSN 0272-8397

G., Mary and Navin, Chand and S.K., Bajpal (2008) A Novel approach to prepare Zn (II) loaded Cotton fibres with antibacterial Property. Journal of Macromolecular Science, 45. pp. 795-803.

K.K., Pathak and P.D., Patil and A.R., Kalinadh and K.C. , Jain (2008) Comparison of Mesh Adaptivity Schemes in Finite Element Simulation of Tube Extrusion Process. Defence Science Journal,, 58. pp. 415-421. ISSN 0304-3894

Majumdar, A.K and J P, Barnwal and Banerjee, P and Jain, R (2008) Development of a New Proximate Analysis Based Correlation to Predict Calorific Value of Coal. Fuel.

Meenal, H and DasGupta, R (2008) High Stress Abrasive Wear Behaviour of Al-2014 alloy and its SiC Composite. International Journal of Microstructure and Materials Properties.

Murari, Prasad and S. , Saxena (2008) Attenuation of divalent toxic metal ions using natural sericitic pyrophyllite. Journal of Environmental Management, 88. pp. 1273-1279. ISSN 0301-4797

Murari, Prasad and Saxena, S (2008) Attenuation of Divalent Toxic Metal Ions Using Natural Sericitic Pyrophyllite. Journal of Environmental Management. ISSN 0301-4797

Murari, Prasad and Sona, Saxena (2008) Attenuation of divalent toxic metal ions using natural sericitic pyrophyllite. Journal of Environmental Management, 88. pp. 1273-1279. ISSN 0301-4797

Murari, Prasad and Sona, Saxena (2008) `Multi-component sorption of Pb(II), Cu(II) and Zn(II) onto low-cost mineral adsorbent’. Journal of Hazardous Materials, 154. pp. 221-229. ISSN 0304-3894

Murari, Prasad and Sona, Saxena (2008) Multi-component sorption of Pb(II), Cu(II) and Zn(II) onto low-cost mineral adsorbent. Journal of Hazardous Materials, 154. pp. 221-229. ISSN 0304-3894

Navin, Chand and A., Nigrawal (2008) Development and electrical conductivity behavior of copper-powder-filled-epoxy graded composites. Journal of Applied Polymer Science, 109. pp. 2384-2387. ISSN 0021-8995

Navin, Chand and A.M., Naik (2008) Development and High stress abrasive behavior of milled carbon fibre reinforced Epoxy gradient composites. POLYMER COMPOSITES, 29. pp. 1-9. ISSN 0272-8397

Navin, Chand and Archana , Nigrawal and Deepak , Jain (2008) Dielectric Behavior of Maleic Anhydride Grafted Polypropylene (MAgPP) Modified Sisal Fiber Reinforced PP Composites. Journal of Natural Fibers. . pp. 270-288. ISSN 1544-0478

Navin, Chand and M., Mehra (2008) Thermal and D C Conductivity Behavior of Fly ash Filled Polyaniline Composites Polymer. Plastics Technology and Engineering, 47. pp. 883-886.

Navin, Chand and M.K., Sharma (2008) Development and sliding wear behavior of milled carbon fiber reinforced epoxy gradient composites. Wear, 264. pp. 69-74. ISSN 0043-1648

Navin, Chand and U.K ., Dwivedi (2008) Influence of Wood Flour Loading on Tribological Behavior of Epoxy Composites. POLYMER COMPOSITES, 29. pp. 1189-1192. ISSN 0272-8397

Nigam, P and Singh, D.K and Lamba, S and Pandit, A and Baderia, V.K. and Tiwari, A and Gowri, V.S and Sanghi, S.K. (2008) Determination of Aliphatic Amines by High-Performance Liquid Chromatography-Amperometric Detection After Derivatization with Naphthalene-2,3-Dicarboxaldehyde. Analytica Chimica Acta. ISSN 0003-2670

Panthi, S.K. and Chouhan, J.S and DasGupta, R and N. , Ramakrishnan (2008) Study of Effect of Load on Springback in Sheet Metal Bending. Transactions of the Indian Institute of Metals.

R K , Morchalle and S.R., Karade and Mohini , Saxena (2008) Redmud polymer composite substitute of wood. Ibid. pp. 417-428.

R.K., Morchale and Mohini , Saxena and S.R., Karade (2008) Redmud polymer composites substitute of wood. ibid. pp. 417-428.

S, Akhtar and K.K., Pathak and S.S., Bhadauria (2008) R Cable Layout Design of Prestressed Concrete Beams Using L Neural Networks. Journal of Struct. Eng, 3. pp. 117-125.

S , Das and D.P., Mondal and N. , Ramakrishnan and Sawla, S (2008) Synergic Effect of Reinforcement and Heat Treatment on the Two-Body Abrasive Wear of an Al–Si Alloy under Varying Loads and Abrasive Sizes. Wear. ISSN 0043-1648

S , Das and Singh, I.B. and Singh, M and D.P., Mondal (2008) Influence of SiC Particle Addition on the Corrosion Behaviour of 2014 Al-Cu Alloy in 3.5% NaCl Solution. Corrosion Science. ISSN http://dx.doi.org/10.1016/0010-938X(90)90015-W

S., Lamba and A., Pandit and S.K., Sanghi and V.S., Gowri and A., Tiwari and V., Baderia and D., Singh and P., Nigam (2008) Determination of aliphatic amines by high performance liquid chromatography-ampromatric detection after derivatization with napthaline -2, 3 dicarboxaldehyde. Analytica Chemica Acta, 614. pp. 190-195.

S.K., Panthi and N. , Ramakrishnan and K.K., Pathak and J S, Chauhan (2008) Prediction of springback in straight flanging using FEM. CMC, 136. pp. 1-7.

Singh, I.B. and Sinha, A.S.K and Ruhi, G. and Dr., O. P. Modi (2008) Effect of Sintering Temperature on Corrosion and Wear Properties of Sol-Gel Alumina Coatings on Surface Pre-Treated Mild Steel. Corrosion Science. ISSN http://dx.doi.org/10.1016/0010-938X(90)90015-W

Subhraminiuam, Anandha and Lord, E.A (2008) Pentagonal and trigonal quasilattices and their approximants. Z. Kristallogr.

U.B., Kodukula and Y.R., Murthy and K.K., Rao and N. , Ramakrishnan and P., Biral and P.C, Naganoor and R., Venugopal (2008) Studies on water-injection cyclone for processing iron ore fines. Minerals & Metallurgical Processing, 25. pp. 79-84.

Xu, H and Murari, Prasad and Liu, Yu (2008) Schorl: A Novel Catalyst in Mineral–Catalyzed Fenton-Like System for Dyeing Wastewater Discoloration. Journal of Hazardous Materials. ISSN 0304-3894