S , Das and Rao, R.N. and D.P., Mondal and Dixit, G (2010) Effect of Heat Treatment on the Sliding Wear Behaviour of Aluminium Alloy (Al–Zn–Mg) Hard Particle Composite. Tribiology International. ISSN 43(2010)330-339

D.P., Mondal and S , Das (2010) Effect of thickening agent and foaming agent on the micro-architecture and deformation response of closed cell aluminum foam. Material Science and Engineering Technology, 41. pp. 276-282.

D.P., Mondal and S , Das (2010) Effect of thickening agent and foaming agent on the microarchitecture and deformation response of closed cell aluminum foam. Material Science and Engineering Technology,, 41. pp. 276-282.

D., Singh and D.P., Mondal and Dr., O. P. Modi and V.K., Sethi (2010) Low stress abrasive wear response of boron steel under three body abrasion: Effect of heat treatment and peening intensities. Indian Journal of Engineering and Material Science, 17. pp. 208-218. ISSN 0971-4588

D.P., Mondal and S , Das and N. , Ramakrishnan and K. Udaya, Bhaskar (2009) Cenosphere filled aluminum syntactic foam made through stir-casting technique. Composites Part A: Applied Science and Manufacturing, 40. pp. 279-288. ISSN 1359-835x

D.P., Mondal and Goel, M.D and S , Das (2009) Compressive Deformation and Energy Absorption Characteristics of Closed Cell Aluminum-Fly Ash Particle Composite Foam. Materials Science and Engineering A. ISSN 0921-5093

D.P., Mondal and M.D., Goel and S , Das (2009) Compressive deformation and energy absorption characteristics of closed cell aluminum-fly ash particle composite foam. Materials Science and Engineering: A, 507. pp. 102-109.

D.P., Mondal and S , Das and Dr., Nidhi Jha (2009) Dry sliding wear behaviour of aluminum syntactic foam. Materials and Design., 30.

R.N., Rao and S , Das and D.P., Mondal and G., Dixit (2009) Dry sliding wear behaviour of cast high strength aluminium alloy (Al–Zn–Mg) and hard particle composites. Wear, 267. pp. 1688-1695. ISSN 0043-1648

D.P., Mondal and Dr., M D Goel and S , Das (2009) Effect of strain rate and relative density on compressive deformation behaviour of closed cell aluminum–fly ash composite foam. Materials and Design, , 30. pp. 1268-1274.

I. B., Singh and D.P., Mondal and M., Singh and S , Das (2009) Influence of SiC particles addition on the corrosion behavior of 2014 Al-Cu alloy in 3.5% NaCl solution. Corrosion Science, 51. pp. 234-241. ISSN http://dx.doi.org/10.1016/0010-938X(90)90015-W

I. B., Singh and D.P., Mondal and M., Singh and S , Das (2009) Influence of SiC particles addition on the corrosion behavior of 2014 Al–Cu alloy in 3.5% NaCl solution. Corrosion Science, 51. pp. 234-241. ISSN http://dx.doi.org/10.1016/0010-938X(90)90015-W

D.P., Mondal and S , Das and A., Badkul and N., Jha (2009) Modelling of Evaporative Cooling of Porous Medium Filled with Evaporative Liquied. CMC-Computers Materials & Continua , 13. pp. 115-134.

D.P., Mondal and Goel, M.D and S , Das (2008) Effects of Strain Rate and Relative Density on Compressive Deformation Behaviour of Closed Cell Aluminum–Fly Ash Composite Foam. Materials & Design.

D.P., Mondal and S , Das and Vinod, E.M and Rao, T.S.V.C (2008) High Sress Abrasive Wear Behaviour of Shot Peened AA2014 Al-Alloy. Indian Journal of Engineering Materials Science.

D.P., Mondal and E.M., Vinod and S , Das and T.S.V.C, Rao (2008) High stress abrasive behavior of shot peened AA2014A1-alloy. Ind J of Engineering and Materials Sciences, 15. pp. 41-50.

S , Das and Singh, I.B. and Singh, M and D.P., Mondal (2008) Influence of SiC Particle Addition on the Corrosion Behaviour of 2014 Al-Cu Alloy in 3.5% NaCl Solution. Corrosion Science. ISSN http://dx.doi.org/10.1016/0010-938X(90)90015-W

D.P., Mondal and E M, Vinod and S , Das and T S V C , Rao (2008) Investigations on d.c. conductivity behaviour of milled carbon fibre reinforced epoxy graded composites. Investigations on d.c. conductivity behaviour of milled carbon fibre reinforced epoxy graded composites, 15. pp. 41-50. ISSN 0971-4588

S , Das and D.P., Mondal and N. , Ramakrishnan and Sawla, S (2008) Synergic Effect of Reinforcement and Heat Treatment on the Two-Body Abrasive Wear of an Al–Si Alloy under Varying Loads and Abrasive Sizes. Wear. ISSN 0043-1648

D.P., Mondal and N. , Ramakrishnan and Suresh, K.S. and S , Das (2007) Compressive Deformation Behaviour of Coarse SiC Particle Reinforced Composite: Effect of Age-Hardening and SiC Content. Materials Science and Engineering A. ISSN 0921-5093

D.P., Mondal and Dr., Dushyant Singh and Dr., K P Saha (2007) Development of mathmatical model for prediction of abrasive wear behaviour in agriculture grade medium carbon steel. Anisotropic abrasive wear behaviour of bamboo , 18. pp. 125-136.

V., Rajput and D.P., Mondal and S , Das and A K , Jha and N. , Ramakrishnan (2007) Effect of Si Cp addition on age hardening of aluminum composite and close cell aluminum composite foam. J Mater Sci, 42. pp. 7408-7414. ISSN .1007/s10853-007-1837-x

Jha, A.K and N. , Ramakrishnan and S , Das and D.P., Mondal and Rajput, V (2007) Effect of SiCp Addition on Age-Hardening of Aluminium Composite and Closed Cell Aluminium Composite Foam. Journal of Materials Science. ISSN 0022-2461

S., Sawla and S , Das and D.P., Mondal and N. , Ramakrishnan (2007) Microstructure and mechanical properties of Al alloy and Al alloy Si Cp composite foam. Trans Indian Inst Met, 60. pp. 495-504.

S , Das and Suresh, K.S. and N. , Ramakrishnan and D.P., Mondal (2007) On the Moduli of Closed-Cell Aluminum Foam. Scripta Materialia.

D.P., Mondal and N. , Ramakrishnan and K.S., Suresh and S , Das (2007) On the moduli of closed cell aluminum foam. Scripta Materialia, 57. pp. 929-932.

M., Singh and D.P., Mondal and S , Das (2006) Abrasive wear response of aluminium alloysillimanite particle reinforced Composite under low stress condition. Material Science and Engineering A, 419. pp. 59-68. ISSN 0921-5093

D.P., Mondal and N. , Ramakrishnan and N.V., Ganesh and V.S., Muneshwar and S , Das (2006) Effeat of SiC concentration and strain rate on the compressive deformation behavior of 2014A1-SiCp composite. Materials Science & Engineering A, 433. pp. 18-31.

D.P., Mondal and N. , Ramakrishnan and S , Das (2006) FEM modeling of the interface and its effect on the elastio-plastic behavior of metal matrix composites. Material Science & Engineering A, 433. pp. 286-290.

D.P., Mondal and S , Das (2006) High Stress abrasive wear behavior of aluminium hard particle composites: Effect of experimental parameters, particle size and volume fraction. Tribology International, 39. pp. 470-478. ISSN 0301-679X

K., Venkateshwarlu and S., Mohapatra and R.G. , Rao and A.K., Ray and L.C., Pathak, and D.P., Mondal (2006) High abrasive wear response of diamond reinforced composite coating:a factorial design approach. tribology letters, 24. pp. 7-14. ISSN 1023-8883

Y.L., Saraswathi and S , Das and D.P., Mondal (2006) Influence of microstructure and experimental parameters on the erosion–corrosion behavior of Al alloy composites. Materials Science & Engineering A, 425. pp. 244-254.

K., Venkateshwarlu and Ajay Kumar , Ray and Manoj Kumar, Gunjan and D.P., Mondal and L.C., Pathak (2006) Pathak Tribological wear behavior of diamond reinforced composite coating. Material Science and Engineering A, 418. pp. 357-363. ISSN 0921-5093

D.P., Mondal and S , Das and R.N., Rao and M., Singh (2005) Effect of SiC addition and running-in-wear on the sliding wear behaviour of Al–Zn–Mg aluminium alloy. Material Science and Engineering A, 402. pp. 307-319.

D.P., Mondal and S , Das and V., Rajput (2005) Effect of zinc concentration and experimental parameters on high stress abrasive wear behaviour of A1-Zn alloys: A factorial design approach. Material Science and Engineering A, 406. pp. 24-33.

Y. L., Saraswathi and S , Das and D.P., Mondal (2005) Erosion-Corrosion Behavior of SiC Particle-Reinforced A1-Si Alloy in NaOH Slurry. Metallurgical and Material Trasactions A, 36A. pp. 2259-2262. ISSN 1073-5623

Yadav, M.S and D.P., Mondal and Dr., A H Yegneshwaran and Jha, A.K and B K , Prasad and DasGupta, R (2003) Effect of sillimanite particle Reinforcement on the dry sliding wears behavior of Aluminum alloy composite. Materials Science and Technology.

Dr., O. P. Modi and D.P., Mondal and B K , Prasad and Singh, M and Khaira, H.K. (2003) Abrasive Wear behaviour of a high carbon steel: effects of microstructure and experimental parameters and correlation with mechanical properties. Material Science and Engineering A. ISSN 0921-5093

B K , Prasad and Dr., O. P. Modi and D.P., Mondal and Dr., M. Singh and Dr., H. K. Khaira (2002) Abrasive Wear Behaviour of a High Carbon Steel: Effect of Microstructure and Experimental Parameters and Correlation with Mechanical Properties. Materials Science and Engineering, 343. pp. 237-242. ISSN 0921-5093

S , Das and D.P., Mondal and Sawla, S and Dixit, S (2002) High Stress Abrasive Wear Mechanism of LM13-SiC Composite Under Varying Experimental Conditions. Metallurgical and Materials Transactions A. ISSN 1073-5623

Jha, A.K and Dr., O. P. Modi and D.P., Mondal and Singh, M (2002) Two-body abrasive wear behaviour of aluminium alloy-sillimanite particle reinforced composite. Wear. ISSN 0043-1648

S , Das and D.P., Mondal (2001) Correlation of abrasive wear with microstructure and mechanical properties of pressure die-cast aluminum hard-particle composite. Met. And Mat. Transactions.

B K , Prasad and M, Singh and D.P., Mondal and A K , Jha (2001) Dry Sliding Wear Behaviour of an Aluminium Alloy-Granite Particle Composite. . Tribology International.

Yegneswaran , A.H. and D.P., Mondal and Jha, A.K (2001) Effect of interlamellar spacing on the mechanical properties of 0.65% C steel. Materials Characterization.

S , Das and S, Gupta and D.P., Mondal and B K , Prasad (2000) Influence of Load and Abrasive Size on the Two-Body Abrasive Wear of Al-SiC Composites. Aluminium Transactions.

B K , Prasad and Dr., O. P. Modi and DasGupta, R and Dr., A K Jha and D.P., Mondal (1999) Erosion-Corrosion Characteristics of Squeeze Cast Aluminium Alloy SiC Composite in Water and Sodium Chloride Solutions Containing Sand. Materials Science and Technology, 15. pp. 933-938. ISSN 0267-0836

B K , Prasad and D.P., Mondal and S , Das (1998) Study of Erosive-Corrosive Wear Behaviour of an Aluminium Alloy Composite through Factorial Design of Experiments. Wear, 217A. pp. 1-6. ISSN 0043-1648